New to Nanocad and this forum. Is there a way to type in the osnap you want. Say if I want to move a line from the end point to the center of a circle I could command move, select the line, type end and pick endpoint of line, type in cen and select center of a circle. When I type in the osnap I want, I get an invalid command. Some osnaps I do not want or need to be on all the time so I might want to invoke it whenever I want without having it turned on. Is this possible?
1
osnap by keyboard
Started by Paul Ronning, Jun 27 2019 02:30 PM
2 replies to this topic
#1
Posted 27 June 2019 - 02:30 PM
#2
Posted 27 June 2019 - 02:41 PM
Hi. I don't know the way to type something in command line to override snap settings in NC 5 free, but you can use osnap override via menu - Shift+RMB.
In NC plus/pro it works also via command line.
In NC plus/pro it works also via command line.
#3
Posted 27 June 2019 - 04:49 PM
I found a toolbar that I can pick from.
Thanks
Thanks
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users