4 replies to this topic

[Rafal Karnicki]

Dear NanoCad,

I have the frustrating problem with object snapping to underlay image frame.
Sometimes I use raster underlays to draw some architectural details. Object snapping helps a lot.
In this process, I use many images and I move or resize them quite often.

But there is an issue. When the cursor is in the area of a raster image and object snapping is on it is attracted to the frame of this image. It causes many errors during the drawing process. Well, the NanoCad 5.0 works better in this way, the cursor is attracted only over the image frame.

I`ve found a partially acceptable solution. I put images on a locked layer and then turn off a selection from the locked layer. It helps but greatly decreases productivity.

How to turn off cursor attraction within image space? (cursor should be attracted only over the image frame)

Please help me

Rafał

[Hellen_V]

Hello Rafal,
try to unselect "Raster objects" snap:

[Rafal Karnicki]

Well...
big red arrow show it in the best way
I've tried and....
...
It works :-D

the simplest solution is the best!

thank You!


ps. it was not so intuitive, the button in "on" state tells rather that snapping is enabled.

[Rafal Karnicki]

but... there is another issue

the OSNAP function does not remember this switch state.

F3 enables/disables the state, but image snapping button state is not restored:-(

[Hellen_V]

Rafal Karnicki, on 14 September 2018 - 01:07 PM, said:

but... there is another issue

the OSNAP function does not remember this switch state.

F3 enables/disables the state, but image snapping button state is not restored:-(

thank you, added this problem to our bug base.