Jump to content

Isometric SNAP

Isometric SNAP

  • You cannot reply to this topic
No replies to this topic

#1 Arun Talukdar


  • Members
  • PipPip
  • 13 posts
  • LocationIndia

Posted 06 September 2018 - 11:43 AM

A command may call ISOPLANE which will allow to easily draw at a 30-degree angle as needed for an isometric drawing. You can switch between the three 'isoplanes' (top, right, left) by using this command or by pressing some functional key on the keyboard.

2 user(s) are reading this topic

0 members, 2 guests, 0 anonymous users