Jump to content


Plot style table multi selection


2 replies to this topic

#1 Mauro Murta

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 07 April 2017 - 07:12 AM

Hello everybody
When I need to change the plot styles, I have to select them one by one. If I press Shift the multi selection does not work, as it does on other softwares like Draftsight. See picture.
Attached Image: Cattura.JPG
Is there any other way to multi select the styles or, if not, will it be a next improvement of the software?
This problem had been raised by a nanoCAD user in 2012. See link below.
http://forum.nanocad...editor-problem/

Thank you
Mauro Murta

#2 Hellen_V

    nanoCAD Team

  • Members
  • PipPipPip
  • 916 posts

Posted 07 April 2017 - 11:44 AM

Hi Mauro,
problem is fixed in nanoCAD Plus/Pro.
nanoCAD Support Team
support@nanocad.com

#3 Mauro Murta

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 07 April 2017 - 12:00 PM

Thank you!
Hope it will be fixed also on the next free versions.





1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users