4 replies to this topic

[Nayara Ferreira]

Selection preview, only works if you select and then execute a command.
If you run a command to then select it no longer works.

Any solution?

[Hellen_V]

Hello Nayara,
turn on the "Keep pre-selection after modification" in Options in nanoCAD Plus:

[Nayara Ferreira]

I did this did not work.

[Hellen_V]

what commands do you run?

[Nayara Ferreira]

Example:
I create a line.
I type the Copy or Move command
Select and move and end the command.
But I want to move or copy again with the same selection
Re-enter the Copy or Move command
But now I give Preview

But it does not select correctly.

Only works in the following order

I create a line.
I select
I type the Copy or Move command
Move and end the command.
That way when I re-type the Copy or Move and Preview command
It correctly selects the last selection.


But I need to remember that if I want to use the preview I have to select before