Hello,
I have nanoCAD 5.0.2520.1471. The zooming with the mouse wheel, works just one time after I open a dwg, after the wheel mouse makes just scrolling. If I close the dwg and reopen it the same think happens.
I have a Logitech M325 wireless mouse. I installed a software from Logitech (setpoint) where I configured the Forward/Back buttons to do zoom In/out for nanoCAD application and the buttons are working just one time (the first time) and after they do scrolling.
Can you advice me what to do?
Thank you!
0
mouse wheel scroll
Started by Iosif Schlahetka, Oct 20 2016 08:38 AM
2 replies to this topic
#1
Posted 20 October 2016 - 08:38 AM
#2
Posted 27 October 2016 - 04:11 PM
Hello Iosif,
not sure for wireless Logitech, I am using Logitech M-U0007 wired mouse and Microsoft wireless 4000 mouse with nanocad without problems, but I am not using special mouse software. If you not use setpoint software - are mouse wheel operations correct?
I'll try to install Logitech software and check, can it works with wired mouse.
not sure for wireless Logitech, I am using Logitech M-U0007 wired mouse and Microsoft wireless 4000 mouse with nanocad without problems, but I am not using special mouse software. If you not use setpoint software - are mouse wheel operations correct?
I'll try to install Logitech software and check, can it works with wired mouse.
#3
Posted 08 November 2016 - 10:02 AM
Hello SevaM,
I have the same behavior with a wired mouse (A4-X7).
I installed the logitech software after I saw this behavior. I hoped that if I configure in the software the Forward/Back buttons to do zoom In/out it will make zoom In/out also in nanoCAD, but is not zooming.
I have the same behavior with a wired mouse (A4-X7).
I installed the logitech software after I saw this behavior. I hoped that if I configure in the software the Forward/Back buttons to do zoom In/out it will make zoom In/out also in nanoCAD, but is not zooming.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users