Jump to content


relative angle tracking

relative angle tracking line

3 replies to this topic

#1 Tom

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 11 October 2016 - 08:13 PM

Hello
Is it possible to set relative to last segment angle tracking during drawing a line?
By default when polar coordinates are chosen angle is specified from the polar axis which is paralel to x axis.

#2 Hellen_V

    nanoCAD Team

  • Members
  • PipPipPip
  • 916 posts

Posted 12 October 2016 - 11:15 AM

relative to any object - no, but you can set custom tracking angle: right click on POLAR in status bar - Set custom angle.
Also you can specify the length and angle of new line segment relative to the last segment: @length<angle.
nanoCAD Plus 8 supports dynamic input, you can set the desired angle.
nanoCAD Support Team
support@nanocad.com

#3 Tom

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 16 October 2016 - 06:09 PM

writing: angle relative to last segment I meant situation like on attached picture. Is it possible draw in this way?

Attached Thumbnails

  • Attached Image: kąt względny.png


#4 Hellen_V

    nanoCAD Team

  • Members
  • PipPipPip
  • 916 posts

Posted 17 October 2016 - 11:47 AM

not possible.
nanoCAD Support Team
support@nanocad.com





1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users