3 replies to this topic

[Roberto Cane']

Hello, this is my first post here.
I have started using NanoCAD 5 early this month, and there is already a problem: I sent by email a number of mechanical drawings to my company, and they told me that is not possible to make changes to some drawings.
Since the company still uses the old AutoCAD LT2000, I always saved the drawings as AutoCAD 2000/LT2000 Compatible Drawing (*.dwg).
They are able to load my files and print them out, but not to modify them because the files are loaded as read-only by their AutoCAD LT2000.
Is this due to a lack of full compatibility, or rather to some setting I haven't noticed yet?
Thanks in advance for any explaination.

--
Robert.

[Hellen_V]

Hello Roberto,
I don't have AutoCAD LT2000 so I can't check the problem...
Advice to your users SAVE AS your files, probably it will solve the problem

[giuseppe]

I have almost the same problem.
I work with Nanocad and save as Autocad 2007/LT2007
If I open the drawing with Autocad 2015, sometimes it couldn't copy/past some objects, with error message: "copy not permetted".
During the opening of file, an allert tell me that I need Nanospds
Can anyone help me, thank you

Giuseppe

[Hellen_V]

giuseppe, on 20 December 2017 - 03:37 PM, said:

Can anyone help me, thank you

Giuseppe

Hello Giuseppe,
what version of nanoCAD do you use?
Also please send me one of your problem files. You can attach it here or send to Support Center: support@nanocad.com