Hi,
I have problem with one of my project,
When I want to save this project, the proces of saving stop on 98% and nothing happens, when I want to close project and it ask me if I want to save it's doing the same (stop on 98%).
After that it shows me "Fatal Error" with description
Problem Event Name: APPCRASH
Fault Module Name: TD_Ge_csd.dll
anyone have the same problem (or solution to solve this problem ?)
I have to add that if I want to copy layer from this project to new one, it happens again
Koala
0
Fatal error when saving a project
Started by Koala, Sep 05 2014 12:54 PM
4 replies to this topic
#1
Posted 05 September 2014 - 12:54 PM
#2
Posted 08 September 2014 - 05:41 AM
hello,
can you send us this file?
can you send us this file?
nanoCAD Support Team
support@nanocad.com
support@nanocad.com
#3
Posted 08 September 2014 - 10:09 AM
I had checked your file.
Use AUDIT and PURGE commands before saving the project, it should help you.
Use AUDIT and PURGE commands before saving the project, it should help you.
nanoCAD Support Team
support@nanocad.com
support@nanocad.com
#4
Posted 08 September 2014 - 10:10 AM
And I have the question: where the file was created?
nanoCAD Support Team
support@nanocad.com
support@nanocad.com
#5
Posted 08 September 2014 - 11:11 AM
Thanks a lot, right now it works normally.
I dont know where exacly was created this file, but I think it was AutoCAD
once again thanks for help
I dont know where exacly was created this file, but I think it was AutoCAD
once again thanks for help
3 user(s) are reading this topic
0 members, 3 guests, 0 anonymous users