Does anyone else have this issue? I save a dwg file and right after saving the text that I had centered lost the centering and turns into left justified.
0
3 replies to this topic
#1
Posted 30 June 2013 - 11:25 PM
#2
Posted 18 July 2013 - 08:04 AM
Hello,
did you save, close and re-open or this happens just after save command?
did you save, close and re-open or this happens just after save command?
#3
Posted 29 July 2013 - 08:46 PM
It seemed to happen right after saving, the text lost it's center. Not sure what the cause is, don't know if it is font dependent. Thank you for replying!
#4
Posted 12 August 2013 - 11:46 PM
Have not observed the problem yet in nanoCAD 5 beta thus far, but only have been checking for about an hour now.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users