Jump to content


edit table

table area

3 replies to this topic

#1 bane andreev

    Newbie

  • Members
  • Pip
  • 5 posts

Posted 22 March 2012 - 07:50 AM

how can I automatically divide the number in the table to get the m2 from cm2 (in AutoCad its conversion factror ). whether is there a bug I can not I edit the table using table edit toolbar, the cell dosnt turn green with left click.

#2 dimpop

    Member

  • NanoSoft
  • PipPip
  • 15 posts

Posted 22 March 2012 - 02:00 PM

Right click on the table to invoke menu and select 'Edit table' command. Edit macros in table cells as you wish. E.g. to convert from square meters to square centimeters you should set conversion factor to 10000.

#3 bane andreev

    Newbie

  • Members
  • Pip
  • 5 posts

Posted 24 March 2012 - 10:06 PM

did get "edit table", but cant find where to edit macros. In table edit, right ckick on cell, click in menu "pick from drawing", then in Value picker click Measure area and I can only get area in units I draw (cm2 because I draw in cm). where to put conversion factor to 0.0001

#4 bane andreev

    Newbie

  • Members
  • Pip
  • 5 posts

Posted 24 March 2012 - 10:08 PM

View Postbane andreev, on 22 March 2012 - 07:50 AM, said:

how can I automatically divide the number in the table to get the m2 from cm2 (in AutoCad its conversion factror ). whether is there a bug I can not I edit the table using table edit toolbar, the cell dosnt turn green with left click.
its a Ctrl+left click. I think it doesnt say so in Help...its only left click





1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users