Jump to content


Circle plot as polygon


3 replies to this topic

#1 Elen Glimois

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 10 February 2020 - 10:49 PM

I start to use nanocad for drawing.

I saw that circle are plot as polygon as output PDF is not clear.
I have some logo and the result in PDF is not clean.

Here is an example of what I get: Attached Image: NanoCad_exampleOfPDFOutput.png

Is it a way to improve the output ?

Thanks for your support

#2 pguimber

    Advanced Member

  • Members
  • PipPipPip
  • 55 posts
  • LocationFrance - Maine et Loire

Posted 11 February 2020 - 02:57 PM

Hello,
if you use the pdf printer of nanocad you can also use other pdf printer , Pdfcreator and similar. what r├ęsult ?

#3 Elen Glimois

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 11 February 2020 - 03:06 PM

I done it with Bullzip printer (it was the only PDF printer to have ARCHD format - ie 36x24 po).

Is it possible to add this format to the internal PDF printer (I tried but I failed) ? If is it possible I would be able to test on other PDF output and give you some feedback.

#4 pguimber

    Advanced Member

  • Members
  • PipPipPip
  • 55 posts
  • LocationFrance - Maine et Loire

Posted 11 February 2020 - 05:02 PM

Normally all pdf printers can print on any format even custom formats, hence the interest when you have only a small printer ...

So you have to give him the information if the desired size is not in stock ...

Put the correct DPI ... 600 mini

Attached Image: Capture01.JPG

https://youtu.be/a-dIVfKNHKs





1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users